How to Install Roller Blinds in Dandenong?

Roller Blinds of Dandenong are easy to fit and they don't take up too much of your time. Follow the instructions given below:

Things you will need:

• Power drill
• A pencil
• Phillips Screwdriver (one with the crossed head)
• Drill Bit
• Flat head Screwdriver
• Box of Screws

Methods of fixing brackets into different materials when installing Roller Blinds in Dandenong is of utter importance.

How to fix your brackets into Concrete, Brick or Plaster?

If you are drilling into concrete, brick or plaster you are to use a 5 mm diameter masonry drill bit. You will also need wall plugs and one inch Phillips head screws.

How to fix your brackets into Wood or Steel?

If you are drilling into wood or steel you have to use a 3 mm diameter high-speed steel drill bit. Quite often in the wood you can secure the screws without any need to pre-drill.

How to fix your brackets into Tiles?

If you are drilling into tiles, cover your drilling point with a masking tape. This shall prevent the drill from slipping. Some important points to remember while installing Roller Blinds in Dandenong:

• Gather your tools & unpack your blind.
• Locate the installation brackets that are supplied as a pair.
• One bracket is utilised with the control side of the blind and the second bracket is utilised with the rotator side.
• The brackets are always mounted so that the inner surfaces face each other. It is important that they’re mounted so that the blinds are level when installed.
• Mark out carefully your drill holes with a pencil making use of the blind brackets. Make sure that the brackets are perfectly level.
• Drill holes and screw the brackets into place.
• Clip the blind into place by simply putting the opposite side to the chain followed by clipping in the chain side.